Two identical burners, of the same brand and capacity, can wear at very different rates depending on where they're installed. The general interval table in our maintenance frequency guide is a starting point; sites along the Marmara and Aegean coastlines, and in dense industrial zones, carry additional environmental factors that can shorten that interval.
Coastal zones: salt air corrosion
At sites along the Aegean coast (İzmir, Aydın, Muğla) and the Marmara coast (Tekirdağ, Kocaeli, Yalova), salt-laden sea air accelerates corrosion on metal surfaces. This can wear a burner's fan housing, electrical connection points and mounting hardware faster than at an inland site. At coastal industrial sites, more frequent visual inspection of electrical connections and housing corrosion is recommended, beyond the standard interval.
Air quality and filter fouling in dense industrial zones
In areas with high industrial density — certain organised industrial zones in Kocaeli, Tekirdağ and İzmir — ambient particulate concentration can be higher. This causes a burner's intake grille and, where fitted, air filter, to foul faster than at a standard site. A blocked intake grille sets up conditions for an air pressure switch fault or incomplete combustion.
Humidity and climate differences
- Marmara's humid climate: higher humidity raises the risk of moisture build-up around electrical connection points and the ignition transformer — a known cause of ionisation signal problems.
- Thrace's cold winters: on sites using liquid fuel, increased viscosity and freezing risk at low temperatures mean the fuel line and filters deserve particular attention at the pre-winter check — see our pre-winter checklist.
Recommended additional checks by region
| Region / condition | Additional attention needed |
|---|---|
| Aegean and Marmara coastline | Frequent visual check of electrical connections and housing corrosion |
| Dense industrial zones (OIZs) | More frequent intake grille and filter inspection |
| Marmara's humid climate | Moisture check on the ignition transformer and electrical panel |
| Thrace's cold winters | Assess fuel line viscosity/freezing risk, prioritise the pre-winter check |
These factors should be assessed alongside our standard maintenance interval table — they supplement the statutory minimum interval, not replace it.
Frequently Asked Questions
Do burners in coastal areas need more frequent maintenance?
The statutory interval stays the same, but because of salt air corrosion risk, more frequent visual inspection of electrical connections and the metal housing is recommended at coastal sites.
How does air pollution in an industrial zone affect a burner?
Higher ambient particulate concentration can cause the intake grille and filters to foul faster than at a standard site, which affects combustion air and efficiency.
What should liquid-fuel sites in Thrace do specifically before winter?
Because fuel viscosity rises and freezing risk increases at low temperatures, the fuel line and filters should be given priority at the pre-winter check. ---
About Beray Enerji
Beray Enerji is an Istanbul-based burner service company operating across Türkiye, with primary coverage in the Marmara, Thrace and Aegean regions. Our regional field experience — from coastal corrosion to industrial zone pollution — lets us offer a maintenance interval tailored to local conditions, backed by a technical team with 30 years of field experience. For a site-specific assessment, contact us on +90 (000) 000 00 00 or at info@berayenerji.com.
Related services: Burner maintenance · Burner repair service · Contact
References
- Regulation on Control of Air Pollution from Heating (Türkiye), Article 17
- EN 676 — Automatic forced draught burners for gaseous fuels
- EN 267 — Automatic forced draught burners for liquid fuels